SCHUBERTH F 220 Gebrauchsanleitung Seite 20

strap can be adjusted and fixed in place at the Velcro mechanism.
Important! The SCHUBERTH F 220 satisfies the requirements of
EN 443:2008 on the retaining system if the chinstrap supplied by the
manufacturer is worn and adjusted according to the provisions.
Operating the visor
When raised and locked in place, the visor of the F 220 protrudes slightly from
the helmet shell. This makes it easy to hinge it down again, even with protective
or work gloves.
By applying appropriate pressure to the lower edge of the visor, the visor can
A
then be raised again and retracted into the helmet shell. The helmet's visor mecha-
nism ensures the visor locks firmly into each end position. The visor must
be properly mounted on the helmet.
Use of the helmet in combination with a mask
The SCHUBERTH F 220 is designed for use with a respirator mask. A respirator mask
can be attached to the helmet by fully inserting the connectors at the sides into the
mask locks located on the left and right sides of the helmet. The mask can be remo-
ved again by pressing the external buttons to open the mask locks and at the same
time pulling it gently towards the rear by means of the laterally mounted mask straps
(locking function). For further details and
instructions on fitting a mask as well as
correct handling and operation thereof,
please refer to the respective
manufacturer's user manual.
21