Cleaning And Care - SCHUBERTH F 220 Gebrauchsanleitung

Use of the helmet with a full-face mask with harness (Ratchet
closure variant)
The lining of the SCHUBERTH F 220 is fitted with a quick-adjustment facility to ena-
ble use with a full-face mask with strap harness. By releasing the button at the sec-
ond hole on the right-hand side of the headband and pulling the headband strap ac-
cordingly you can quickly and individually adjust the helmet width to enable you to
wear a full-face mask with strap harness in combination with the helmet.
Adjustment: First check for correct size adjustment of the headband without the
mask and, where necessary, adjust accordingly by inserting the studs into the corre-
sponding holes in the holed section on the left side (see also "Size adjustment").
1) Press and release the button (F) on the head
ring's quick-release fastener.
2) The headband can now be pulled apart as
far as the bridge (G) of the holed section.
3) Now put on the mask and make the
corresponding adjustment with the holed
section (H) so that the helmet now
fits properly even with the mask straps.
Having done this, close the headband again at the quick adjuster and press the but-
ton into place. The normal helmet width has now been adjusted and the quick adjust-
er can be used at any time by releasing the button.

Cleaning and care

The helmet shell and inner lining should only be cleaned with lukewarm soapy water.
The lining of the helmet can also be treated with disinfectant (e.g. Heliosept Medical
Spray). Use correspondingly approved cleaning agents and disinfectants only! On no
account use solvents.
The integrated visor too should only be cleaned by gently rubbing with lukewarm wa-
ter and soap and then rinsed clear and wiped dry. An alcohol-free window-cleaning
product may also be used to clean the visor. Correct cleaning, care and handling of
the helmet are essential for ensuring that it functions optimally.
22
F
G
H