Connecting The Aniusb-Matrix To A Computer; Using Intellimix-Powered Microphones With The Aniusb-Matrix - Shure ANIUSB-Matrix Bedienungsanleitung

② Analog Input Sources
Analog sources (such as wireless microphones or any line-level devices) connect to the analog line input.
③ Analog Output Devices
Loudspeakers, amplifiers, or recording devices connect to the analog line output.
④ Dante-Enabled Microphone
Dante microphones, such as the Shure Microflex Advance ceiling and table arrays, connect to the network switch and can
be routed to the USB channel on the ANIUSB.
⑤ Control Computer
A computer connected to the network accesses Shure Designer to control the channel levels and processing.
⑥ Network Switch
The network switch provides Power over Ethernet (PoE) to the ANIUSB, while also supporting all other Dante-enabled au-
dio equipment.

Connecting the ANIUSB-MATRIX to a Computer

Connect the ANIUSB-MATRIX to a computer with conferencing software using the USB port.
When the ANIUSB-MATRIX is connected for the first time, the computer recognizes it as a USB audio device. You may need to
select it as the input/output (recording/playback) device to pass audio. Assign the ANIUSB-MATRIX as the default device to en-
sure it passes audio every time it is plugged in. Refer to the manual for your computer to configure the audio settings.
Routing Audio Channels to the USB Port
You can route audio to and from the ANIUSB using Dante Controller or Shure Designer software. Use the ANIUSB's matrix mi-
xer to route Dante and analog channels to the USB port.
Step 1: Dante Controller or Shure Designer
1. Open Dante Controller or Shure Designer and route Dante devices (such as MXA or MXW microphones) to the
ANIUSB's Dante input channels. Name the channels to keep track of devices.
2. If you need to send channels from the ANIUSB to other Dante-enabled devices (such as an amplifier, loudspeaker, or
recording device), route the ANIUSB's Dante output channels to the appropriate devices in Dante Controller.
Note: Shure Designer creates Dante audio routes between Shure devices. To create Dante audio routes with non-Shure Dante devices, use Dante
Controller.
Step 2: Matrix mixer
1. Open the ANIUSB's matrix mixer to route Dante and analog channels to the USB port.
2. Assign the USB Input channel (far-end audio) to the appropriate outputs. If recording a meeting, be sure to route the
near-end microphones and the USB input to the recording device.
Adapter Compatibility
This device is compatible with USB-B to USB-C adapters. Using an adapter is only recommended for desktop and laptop com-
puters, as many mobile devices do not support bi-directional audio through USB or lightning ports.

Using IntelliMix-Powered Microphones with the ANIUSB-MATRIX

If you connect microphones that have IntelliMix DSP (MXA710, MXA910) or other acoustic echo cancellation (AEC) processing
to the ANIUSB-MATRIX, you may need to set the USB device type.
Shure Incorporated
15/35