Model
Speed
8.3.4 Lubricate the rotating union
Abb. 12: Attach grease gun for relubri-
cation
8.4
Service life of bearings
Q The rolling bearings used are to be replaced after 4,000 operating hours in the hazardous area.
When this period has elapsed, the rotating union is to be replaced.
Q Depending on the operating conditions, shorter periods may be selected by the operator.
9
Trouble Shooting
This chapter provides the following information:
1. Which problem may occur?
2. What can be the cause of the problem?
3. How can you eliminate this problem?
Rev. E
Operating Manual
The following paragraphs describe how to place the grease
gun and inject the stated volume of grease into the ball bear-
ing.
1. Attach the grease gun to the lubricating nipple (see arrow).
2. Ensure that the connector of the grease gun is placed cor-
rectly on the lubricating nipple.
3. Actuate the grease gun in order to inject the stated volume
of grease into the ball bearing.
4. Count the operating hours for the following lubrication in-
terval.
Page 40 of 49
Model/Series:
54, 55 & 57 EX
Number:
040-650
GB
Version:
2017-05
©DEUBLIN