Safety; General Safety Precautions - Daikin UATYA-BBAY1 Montage- Und Betriebsanleitung

2

SAFETY

2.1 General safety precautions

Access to the area around the unit must be prevented by special guarding where this is positioned in a location that
is not protected and can be reached by unqualified persons.
The equipment operator is responsible for complying with regulatory obligations.
The equipment operator is the person who has actual control over the technical operation and free access, which
means the possibility of monitoring its components and their operation and the possibility of granting access to third
parties.
The equipment operator has the power to decide on technical modifications, checks and repairs.
The equipment operator may give instructions to employees or to external companies for carrying out maintenance
and repair operations.
Access to the unit must be granted exclusively to technicians authorised by the equipment operator.
The equipment must be installed and maintained or repaired by staff and contractors who hold a relevant certificate
issued by a certification body. Within Europe, the certification body must be designated by a member state to certify
compliance with the requirements laid down in Regulation (EU) No 517/2014 of the European Parliament and of the
Council of 16 April 2014 on fluorinated greenhouse gases and repealing Regulation (EC) No 842/2006 Text with EEA
relevance.
Any operator gaining access to the unit must be authorised and qualified as specified by Annex HH of IEC 60335-2-
40:2018, by local legislations and, with respect to europen standards, by EN 378-4 and EN 13133 ", additionally, they
must have proper knowledge to perform all the activities required throughout the service life of the machine.
Access to the unit requires that the closing panels, where fitted, are removed.
On no account must unqualified personnel be allowed to enter the unit and no one should be allowed to enter before
the power to it has been turned off.
The user can interact with the unit only through the control and external OK signals.
Only authorised knowledgeable personnel may access the unit in compliance with safety in the workplace regulations.
At European level, refer to Council Directive 89/391/EEC of 12 June 1989 on the introduction of measures to
encourage improvements in the health and safety of workers at work.
Also, knowledge and understanding of the manual are indispensable for reducing risks and for improving the health
and safety of workers.
The operator must know what to do when faced with possible anomalies, malfunctions or conditions of danger to
himself or others, and in any case, he must comply with the following instructions:
Stop the unit immediately by using the emergency device.
Do not do anything that goes beyond your duties and technical knowledge.
Inform the manager immediately and do not take personal initiatives.
Before carrying out any work on the unit, make sure you have turned off the power supply to it. Refer
to the section on maintenance work.
Before work is started on the unit: check for potentially flammable atmospheres; Make sure there are
no possible ignition sources comply with the requirements specified by Annex HH of standard IEC
60335-2-40:2018, by local legislations, and, with respect to europen standards, by EN 378-4 and EN
13133", and by existing local regulations.
We reserve the right to make changes without any prior notice.
UATYA
4P645202-1
Translation from original instructions
Packaged Rooftop
9