Inhaltsverzeichnis
Werbung
No Printing Results/Printing Is Blurred/Colors Are Wrong/White Streaks
Remove the FINE Cartridge, then reinstall it. The print result may be improved by reinstalling the
FINE Cartridge.
Also, check that the protective tape (A) is removed.
Check 3: Print the Nozzle Check Pattern and perform any necessary
maintenance operations such as Print Head Cleaning.
Print the Nozzle Check Pattern to determine whether the ink ejects properly from the print head
nozzles.
Refer to
Routine Maintenance
Head Deep Cleaning.
If the Nozzle Check Pattern is not printed correctly:
After performing the Print Head Cleaning, print the Nozzle Check Pattern and examine the
pattern.
If the problem is not resolved after performing the Print Head Cleaning twice:
Perform the Print Head Deep Cleaning.
If the problem is not resolved after performing the Print Head Deep Cleaning, try it again.
If the problem is not resolved after performing the Print Head Deep Cleaning twice:
Ink may have run out. Replace the FINE Cartridge.
Check 4: When a FINE Cartridge runs out of ink, replace it with a new
one.
Check 5: When using paper with one printable surface, make sure that
the paper is loaded with the printable side facing up.
Printing on the wrong side of such paper may cause unclear prints or prints with reduced quality.
Refer to the instruction manual supplied with the paper for detailed information on the printable side.
Check 6: Change the Paper Thickness Lever setting.
Adjust the position of the Paper Thickness Lever according to the type of paper you are printing on.
Refer to
Loading Paper
Depending on the printing content, the printing surface may become scratched or the corners or
edges of the paper may become smudged even for the types of paper which require you to set the
lever to the left. In this case, set the Paper Thickness Lever to the right.
* Reset the Paper Thickness Lever to the left when you finish printing. If the lever is not set back to
the left, the inside of the printer is more likely to get dirty due to the wider clearance between the print
head and the loaded paper. It may also reduce print quality.
for the Nozzle Check Pattern printing, Print Head Cleaning, and Print
.
Стр. 287 из 342 стр.
Werbung
Inhaltsverzeichnis
