HBM QuantumX Kurzanleitung Seite 22

22
• Install and then start the latest QuantumX Assistant on your PC.
• Click on the icon
The field "Modules found" displays all modules connected via FireWire.
• If your modules are not yet displayed, mark "Search the complete network"
and click again on the
• Mark the relevant modules by checking the relevant checkbox
• Confirm with "OK"
This completes the settings for your connection. Connect your transducer
now, connection information can be found in the "QuantumX operating
instructions".
Information about further channel configuration can be found in the online help
of the HBM software you are using.
NOTE
If no modules are found via FireWire this may be caused by the
following:
− The modules have not been properly registered. Click on the FireWire
driver in Systray, check the driver behind the modules and reinstall it,
if necessary (hbm1394.sys).
− Check all connections between the modules.
HBM
(Find modules) or press the function key F4.
QuantumX
button.
A2361-3.2 en/de