HBM QuantumX Kurzanleitung Seite 17

17
QuantumX
• Click on "OK"
• Confirm the settings with the "Yes" button, the module is then restarted with
the current settings.
After approx. 45 seconds click on the button.
The system LED of the module should now light up green, if not please check
your network settings again! If the network settings are ok, the module names
are shown in black.
• Mark the relevant modules by checking the relevant checkbox
• Confirm with "OK" and you are now ready for your first measurement job
Connector pin-outs can be found in the operating manual.
Channel configuration can be found in the online help of the software.
HBM
A2361-3.2 en/de