HBM QuantumX Kurzanleitung Seite 15

QuantumX
If the module you have selected appears in black in the list, immediate
operation is possible.
If the module appears gray in the list, mark it and click on the "Edit network
settings" button.
Check your settings and adjust if necessary as follows:
Adapt the IP address of the module in the following way:
• Activate DHCP/APIPA if you want automatic configuration as used with
your PC or Notebook
• Deactivate DHCP and enter the same subnet mask address as used with
your PC and change the IP address of your module so that it matches
communication (see example below)
Example: Manual IP setting − module side
Settings
Module before
PC / Notebook
Module after
The first three digit groups of the PC and module IP addresses shall be the
same. The last digit group must be different (do not use DHCP with a direct
connection between PC and module).
The subnet mask address digit groups must be identical in the module and
PC!
A2361-3.2 en/de
IP address
169.1.1.22
172.21.108.51
172.21.108.1
15
Subnet mask
255.255.255.0
255.255.248.0
255.255.248.0
HBM