Intended Use; Safety Instructions - FLORABEST 318051 1904 Aufbauanleitung

Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following assembly
instructions and the safety infor-
mation carefully.
Use the product only as described and only
for the given areas of application. Store these
assembly instructions carefully. When passing
the product on to third parties, please also hand
over all accompanying documents.
Scope of delivery (fig. A)
1 x frame section (1)
1 x frame section (2)
2 x frame section (3)
2 x frame section (4)
1 x shelf (5)
1 x decorative moulding (6)
1 x decorative moulding (7)
1 x shelf (8)
1 x moulding (9)
1 x shelf (10)
1 x decorative moulding (11)
1 x tilt protection (12)
11 x screw (13)
20 x screw (14)
1 x screw (15)
1 x nut (16)
1 x ring spanner (17)
1 x spanner (18)
1 x assembly instructions
Technical data
Dimensions: approx. 85 x 60 x 60 cm (w x h x d)
Maximum load (per shelf):
25
25 kg
Date of manufacture (month/year):
11/2019

Intended use

This product is used to arrange e.g. flowerpots
and decorations. The product is intended for
private use indoors and outdoors.
8 GB/IE/NI

Safety instructions

Important! Read these assembly
instructions carefully and be sure to
keep them handy!
Danger to life!
• Never leave children unsupervised with the
packaging material. Risk of suffocation.
Risk of injury!
• Before using the product check for correct
stability.
• Position the product on an even surface.
• The product may only be used under adult
supervision and not as a toy.
• The product is not for climbing on or playing
with! Make sure that people, especially
children, do not pull themselves up on the
product or lean against it. The product may
tip over.
• Check the product for damage and wear
before each use. Check regularly that all
screw connections are tight!
Assembly
1. Screw together the sections (1), (2), (3), and
(4) to form side parts, tightening the screws by
hand (14) (fig. B).
Important: The holes for the shelves of
the stand must face upwards!
2. Push the side sections together (fig. C).
3. Attach the decorative mouldings (6), (7), and
the tilt protection (12) below the shelf (5)
using the screws (13) (fig. D).
4. Attach the decorative moulding (9) below the
shelf (8) using the screws (13) (fig. E).
5. Attach the decorative moulding (11) below
the shelf (10) using the screws (13) (fig. F).
6. Place the shelf (5) on the product and screw it
on using the screws (14) (fig. G).
7. Repeat step 7 with shelves (8) and (10) (figs.
H and I).
8. Tighten all screws firmly.
9. Stand the product upright on the ground (fig. K).