Intended Use; Safety Instructions - FLORABEST 318019 1904 Aufbauanleitung

Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following assembly
instructions and the safety infor-
mation carefully.
Use the product only as described and only
for the given areas of application. Store these
assembly instructions carefully. When passing
the product on to third parties, please also hand
over all accompanying documents.
Scope of delivery (figure A)
1 x Shelf (1)
3 x Plastic feet (2)
1 x ½ plastic foot (3)
1 x Screw foot (4)
1 x Tilt protection for wall mounting
1 x Fabric strip (5)
1 x Dowel (6)
1 x Washer (7)
1 x Screw (8)
1 x Assembly Instructions
Technical data
Dimensions: approx. 50 x 178 x 36cm
(W x H x D)
Maximum load (per floor):
10
10 kg
Date of manufacture (month/year):
11/2019

Intended use

This article serves as a stand for potted plants
and decorations, for example.
The article is designed for use in living areas or
outdoors on a balcony, terrace, or conservatory
for private use.
4 GB/IE/NI

Safety instructions

Danger to life!
• Never leave children unsupervised with the
packaging material. Risk of suffocation.
Risk of injury!
• Before using the product check for correct
stability.
• Position the product on an even surface.
• The product may only be used under adult
supervision and not as a toy.
• The product is not for climbing on or playing
with! Make sure that people, especially
children, do not pull themselves up on the
product or lean against it. The product may
tip over.
• Check the product for damage and wear
before each use. Check regularly that all
screw connections are tight!
Assembly
Important: assembling the product
requires at least two people.
1. Remove the shelf (1) from the packaging and
lay it flat on the floor.
Note: hard surfaces can scratch the item!
2. Insert the plastic feet (2) into the bottom of the
tube legs on the article (figure B).
Important: make sure that you place
the plastic half-feet on the ends of the
back tubes.
3. Screw the screw foot (4) under the front of the
shelf floor (figure C).
4. Put the article on the plastic feet and unfold it
(figure C).
Caution: when unfolding the sidewalls
the shelves can fall down independently.
5. Fold down the shelves in such a way that they
hook into the locking mechanism (figure D).
6. Position the locking pin on the lower shelf
figure E).