Specifications - Makita BDF440 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Battery cartridge
1-2. Button
1-3. Red part
2-1. Switch trigger
3-1. Lamp
4-1. Reversing switch lever
5-1. Speed change lever
6-1. Adjusting ring

SPECIFICATIONS

Capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling and screw driving in wood,
metal and plastic.
For Model BDF440
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Downloaded from www.Manualslib.com
Explanation of general view
6-2. Graduations
6-3. Pointer
7-1. Sleeve
8-1. Screw
8-2. Hook
8-3. Groove
10-1. Limit mark
11-1. Rear cover
Model
Steel
Wood
Wood screw
Machine screw
High (2)
-1
)
Low (1)
Overall length
Net weight
Rated voltage
) : 73 dB(A)
pA
Wear ear protection.
2
) : 2.5 m/s or less
h,D
2
manuals search engine
BDF440
1.6 kg
D.C. 14.4 V
ENE034-1
For Model BDF450
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
ENG104-2
The noise level under working may exceed 80 dB (A).
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: drilling into metal
Vibration emission (a
ENG202-3
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
3
11-2. Screws
12-1. Spring
12-2. Arm
12-3. Recesed part
13-1. Carbon brush cap
14-1. Hole
14-2. Carbon brush cap
BDF450
13 mm
27 mm
ø 6.8 mm x 50 mm
M6
0 - 1,400
0 - 400
186 mm
1.7 kg
D.C. 18V
) : 72 dB(A)
pA
Wear ear protection.
2
) : 2.5 m/s or less
h,D
2
ENG104-2
ENG202-3
ENG901-1