Nikon Lite Touch Zoom 140 ED Bedienungsanleitung Seite 43

*
A characteristic of electronic cameras
In rare cases, when strong static electricity or the like is applied to
the camera, the camera may not work properly.
If this happens, remove the battery and re-install it.
When the battery is removed, the date/time you set are cleared.
Reset them after reinstalling the battery. (
Downloaded from www.Manualslib.com
Problem
a Camera shake.
a Something in front or in back of the subject is in
The subject
appears out of
focus in the print.
No indicator
a The battery is installed with wrong polarities.
appears even
when the camera
a No battery or dead battery.
is turned on.
The numeral " "
a The letter " " blinks or lights up.
does not appear
even when film is
loaded.
a You are out of the remote control working range.
a Two or more minutes have elapsed since you set
The shutter
cannot be
released using
the remote
a The remote control is operated in backlit.
control.
a The service life of the battery in the remote
When the battery is replaced or re-installed, the date and time you set are cleared.
Reset them. ( p. 41)
manuals search engine
Check points and solution
→ Gently press the Shutter Release button, or use a
tripod or place the camera on a stable flat surface.
focus.
→ Be sure to center the autofocus frame mark on
the subject before releasing the shutter. When
correct focus cannot be easily achieved, use
the focus lock.
→ Install it with the correct polarities.
→ Install a new battery.
*
→ Remove the film and load it again.
→ Operate the remote control in a range within
5m facing the camera.
the camera to the Remote Control mode.
→ Set the camera to the Remote Control mode
again.
→ Change the position of the remote control.
control has lapsed (5 years).
→ Install a new battery.
Additional Information
Ref. page
18,19
33,35
22,26
27
* 12
12,13
14,15
39
39
39
40
p. 41)
43
E