Daikin EKHH2E200AAV3 Installations- Und Gebrauchsanleitung Seite 32

Parameter description
Work set change block
Delay in equipment start-up
Delay as from last ON
Delay as from last OFF
Minimum ON time
Number of compressor operating hours
required for maintenance
Delay air temperature sample taking for cold
evaporator test
Minimum delay between fan start-up and
compressor activation for incoming air
temperature check
Timeout solar thermal cycle
Delay for damaged fan check
Type of defrosting
Evaporator temperature to conclude
defrosting procedure (only if P4=1)
Maximum duration of defrosting procedure
Automatic defrosting start threshold
(evaporator temperature)
Minimum compressor start up time to start
defrosting procedure
Minimum level probe alarm
(only AL1 warning)
Minimum alarm set (only AL1 warning)
Type of minimum level alarm delay
(only AL1 warning)
Maximum level probe alarm (only AH warning)
Maximum alarm set(only AH warning)
Type of maximum level alarm delay
(only AH warning)
Minimum level AL1 alarm delay due to
equipment start-up (only warning)
AL1 and AH temperature alarm delays
(only warning)
Page 32
Code U.M. Min Max
r5 ---- 0 1
C0 min 0 240
C1 min 0 240
C2 min 0 240
C3 sec 0 240
C10 h 0 9999
C11 min 0 999
C12 min 0 240
C13 min 0 240
C14 min -1 240
d1 ---- 0 2
d2 °C/°F -50.0 50.0
d3 min 0 99
d17 °C/°F -50.0 50.0
d18 min 0 240
A0 ---- 0 2
A1 °C/°F 0.0 50.0
A2 ---- 0 1
A3 ---- 0 2
A4 °C/°F 0.0 199.0
A5 ---- 0 1
A6 min 0 240
A7 min 0 240
Default Notes
1 = It is not possible to
change the set point; it can
0
only be seen
5
5
Compressor protections
5
0
1000 0 = Function excluded
120
1
20
20 -1 = disabled function
0 = With heating element
1 = With hot gas
1
2 = With compressor
stopped
3.0
8
-2.0
60
0 = Upper probe
0 1 = Lower probe
2 = Evaporator probe
10.0
0 = Disabled
0
1 = Absolute
0 = Upper probe
0 1 = Lower probe
2 = Evaporator probe
90.0
0 = Disabled
0
1 = Absolute
120
15
Installation and user manual