Gazelle Shimano Steps Schnellstart Seite 58

„ Turning the light ON/OFF
If a light is connected to the drive unit, this product can be used to operate the light.
Switching light on/off
Press the light button to switch the lights on or off.
1.
Press the light button.
Changing cycling data
The display can show 4 types of cycling data (D) . Press Button A to switch between these.
• The light power is linked with the main power. The light cannot be turned ON when the main power is OFF.
The cycling data change in the following order when Button A is pressed.
VALUE
[GEAR]
[RANGE]
[DST]
[ODO]
Resetting distance cycled
1. On the main screen: press Button A. (Switches the display with cycling data to [DST])
2. Press and hold Button A. (Keep the button pressed until the figure for [DST] flashes)
3. When the figure for [DST] flashes: press Button A.
4. The cycling data has now been reset.
Assistance whilst walking with the bike
1. Stop and switch to the walk assist mode. Press and hold ButtonY until icon (G) is
displayed
2. Push the bike carefully whilst pressing the same button again. When you release ButtonY,
the assistance stops.
3. Leave the walk assist mode. Press button X
58
Light button
EXPLANATION
Current gear position (Only available with electronic gear shifting)
Range (The current range based on the selected assistance level)
Distance cycled
Total distance travelled
10