Ordering Accessories - Philips PowerPro FC8768 Bedienungsanleitung

Cleaning the Super Clean Air HEPA ilter
Clean the Super Clean Air HEPA ilter every 6 months. You can clean the Super Clean Air Hepa
ilter max. 4 times. Replace the ilter after it has been cleaned 4 times.
To detach the ilter grille, push the tab downwards (1) and pull the grille towards you
1
(2). (Fig. 36)
Pull out the Super Clean Air HEPA ilter by pulling the tab towards you. (Fig. 37)
2
Rinse the ilter under a warm slow-running tap (Fig. 38).
3
Never clean the ilter with a brush.
Carefully shake the water from the surface of the ilter. Let the ilter dry completely (at least
4
2 hours) before you put it back into the vacuum cleaner.
Note: Cleaning does not restore the original colour of the ilter, but does restore its iltration power.
Click the ilter back into place (Fig. 39).
5
Note: Make sure the tab of the ilter is located at the top.
Reattach the ilter grille to the vacuum cleaner. (Fig. 40)
6
replacing the super Clean air hEpa Filter
Caution: Use only original Philips ilters.
To detach the ilter grille, push the tab downwards (1) and pull the grille towards you
1
(2). (Fig. 36)
Pull out the Super Clean Air HEPA ilter pulling the tab towards you (Fig. 37).
2
Click the new Super Clean Air HEPA ilter into place. (Fig. 39)
3
Note: Make sure the tab of the ilter is located at the top.
Reattach the ilter grille to the vacuum cleaner. (Fig. 40)
4
storage
1 Switch off the appliance and remove the mains plug from the wall socket.
2 Press the cord rewind button to rewind the cord (Fig. 41).
Put the appliance in upright position. Insert the ridge on the nozzle into the storage slot to
3
store the tube, adjust the tube to the shortest length and then put away the
appliance. (Fig. 42)

ordering accessories

To purchase accessories for this appliance, please visit our website www.philips.com/shop. If you
have any dificulties obtaining accessories for your appliance, please contact the Philips Consumer
Care Centre in your country. You will ind its contact details in the worldwide guarantee lealet. You
can also visit www. philips.com/support.
Ordering ilters
HEPA ilters are available under type number FC8038.
-
Foam ilters are available under type number 4322 004.9369.0.
-
English
11