Philips PowerPro FC8768 Bedienungsanleitung Seite 10

English
10
1 Press the dust bucket release button, grab the dust bucket handle and lift the dust bucket out
of the appliance. (Fig. 23)
2 Remove the lid of the dust bucket (Fig. 24).
3 Empty the dust bucket into a dustbin (Fig. 25).
4 Reattach the dust bucket lid (1) and close it (2) (Fig. 26).
5 Put the dust bucket back into the appliance and push down the top handle ('click') (Fig. 27).
Caution: You should not rinse the dust bucket under the tap. If you accidentally did this anyway,
make sure that you remove and dry the detachable cover before you put the dust bucket back
into the appliance. (Fig. 28)
Cleaning and replacing the ilters
Caution: Do not use any other ilters. Use only original Philips HEPA ilters. For more
information on ordering HEPA ilters, see chapter 'Ordering accessories'.
Note: In case of normal use you do not have to replace the main ilter.
Note: Only replace the foam ilter when it is very dirty and cannot be cleaned properly or when it is
damaged.
Cleaning the foam ilter and the main ilter
Caution: For the best performance, clean both the main ilter and the foam ilter at least 4 times
a year.
Caution: Do not attempt to make the ilter yourself, but only use an original Philips ilter.
Remove the dust bucket and pull the main ilter towards you (Fig. 29).
1
Take the blue foam ilter out of the main ilter. (Fig. 30)
2
Tip: To prevent dirty hands, you can use the tag to remove the ilter.
Clean the foam ilter and the main ilter under the tap (Fig. 31).
3
Never use a brush or cleaning agent to clean the foam ilter and the main ilter. Do not clean
them in the washing machine or dishwasher either.
Note: Cleaning does not restore the original colour of the ilter, but it does restore its iltration power.
Wring out the blue foam ilter (Fig. 32).
4
Let the foam ilter and the main ilter dry for at least 24 hours, out of direct sunlight (Fig. 33).
5
Make sure that the foam ilter and the main ilter are completely dry.
Do not dry the foam ilter and the main ilter on the radiator or in the tumble dryer.
Press the foam ilter back into the main ilter. (Fig. 34)
6
Reattach the main ilter to the dust bucket (Fig. 35).
7