Steinbach BP-39WS-B Mini Originalbetriebsanleitung Seite 57

The display shows the desired parameter (A, C, 1-8) (see "Parameters").
14
3. Press the SET button
The value of the selected parameter blinks on the display
Set parameter
1. Repeatedly press the Up button
The desired value of the selected parameter blinks on the display
2. Press the SET button
The desired value of the selected parameter is set.
Deinstallation
Risk of injury when moving heavy equipment!
The device is heavy! Incorrect lifting or uncontrolled tipping of the
device can result in injuries or damage to the device.
- Only lift, carry or tip the device with two people, never alone.
- Pay attention to maintaining proper posture (straight back,
secure footing, etc.).
- Use transport aids (e.g. pallet truck, or creeper dolly).
- Wear protective equipment such as safety footwear or gloves.
Disconnecting the supply lines
Disconnecting the electrical
1. Put the heat pump into the Standby mode (see the chapter on "Display").
2. Press the RESET button
3. Disconnect the RCD adapter
The heat pump is now disconnected from the electrical supply.
Disconnecting the water lines
1. Switch off the water treatment pump.
2. Loosen the hose clamps
3. Pull the end of the hose off the adapter
When removing the end of the water hose, hold it with the opening facing upwards
to prevent uncontrolled spilling of the remaining water present in the hose.
to select the desired parameter.
18
or the Down button
16
.
18
CAUTION!
.
12
from the electrical supply.
C
of the adapters
3
on the inlet water connection
2
.
14
.
17
14
.
2
.
.
7
57