Steinbach BP-39WS-B Mini Originalbetriebsanleitung Seite 56

The LED lights up. The heat pump is supplied with electricity and is in the Standby
11
mode.
The residual current device of the RCD adapter has now been tested successfully.
Activating the heater
The temperature range that can be set in operating mode is 15-35°C. The standard value
of the set water temperature is 27°C.
You can heat the water in the pool fastest with maximum water flow through
the heat pump (see section "Technical data"). However, increasing the
throughput reduces the dwell time at the heat exchanger. As a result, the
total temperature difference between the water in the pool and the heated
water at the inlet of the pool is smaller and therefore less perceptible.
Please measure and write down the change to the current water
temperature every 30 minutes to detect the actual heating of the pool
water.
Activating operating mode
1. Press the RESET
12
The LED is lit. The heat pump is being supplied with power and is in standby mode.
11
2. Press the ON/OFF
The heat pump is in operating mode and the display
1
temperature in °C.
Setting the desired water temperature
1. Repeatedly press the Up
The display shows the desired water temperature in °C.
14
The heat pump does not work if the set desired water temperature is below
the measured current water temperature.
Showing or setting parameters
The heat pump has 10 parameters that can be shown or set via the display
"Parameters").
Show parameter
1. Press and hold the SET button
mode.
The display shows "A".
14
2. Repeatedly press the Up button
56
button.
button.
15
or Down button.
16 17
for 5 seconds while the heat pump is in operating
18
or the Down button
16
shows the current water
14
D
.
17
(see