Steinbach BP-39WS-B Mini Originalbetriebsanleitung Seite 46

- Never pull the power cable to disconnect the power plug from
the socket. Always disconnect by holding the power plug.
- Never use the power cable as a carrier handle.
- Keep the heat pump, power plug and power cable away from
open fires and hot surfaces.
- Make sure that the power cable does not present a trip hazard.
- Do not bend the power cable or position it over sharp edges.
- Make sure that children do not put objects into the heat pump.
- Keep the openings free from foreign objects.
- When the heat pump is not in use, is being cleaned, or if a fault
occurs, always switch off the heat pump and disconnect its power
plug from the socket.
- Make sure that the actual operating voltage does not deviate
from the nominal value by more than 10% (see "Technical Data").
- As a protective device, the heat pump must have a circuit breaker
with a 16 A slow-blow fuse; this protective device may only feed
the heat pump. Even when using a protective device with all-pole
disconnection, it must still have a differential switch with a
differential current not exceeding 30 mA.
- Make sure that the electrical system to which the heat pump is
connected contains a grounding conductor.
- If a power plug is going to be installed for connection to the
mains, it must have a protection level of at least IPX4 and a
terminal for connecting the grounding conductor. The same
applies to the power supply cable, which must also have a
grounding conductor.
- Protect the power cable and the power plug from rain and
moisture.
- Protect the power cable and the power plug from damage.
46