Operation; Maintenance - Makita DUC256 Betriebsanleitung

OPERATION

Lubrication
Saw chain is automatically lubricated when the tool is
in operation. Check the amount of remaining oil in the
oil tank periodically through the oil inspection window.
To refill the
the chain saw
side, then push the oil tank cap, and then
remove the oil tank cap.
amount of oil
ml. After refilling
that the oil tank cap is tightened securely.
►
Fig.18: 1. Oil tank cap 2. Oil inspection
window
After refilling, hold
saw away from
Start it and wait until lubrication on saw chain is
adequate. ►
Fig.19
NOTICE:
When filling the chain oil for the first
time, or refilling the tank after it has been
completely emptied, add oil up to the bottom
edge of the filler neck. The oil delivery may
otherwise be impaired.
NOTICE:
Use the saw chain oil exclusively for
Makita chain saws or equivalent oil available in
the market.
NOTICE:
Never use oil including dust and
particles or volatile oil.
NOTICE:
When pruning trees, use botanical oil.
Mineral oil may harm trees.
NOTICE:
Before the cutting operation, make
sure that the provided oil tank cap is screwed in
place.
WORKING WITH THE CHAIN SAW
CAUTION:
Keep all parts of the body away
from the saw chain when the motor is operating.
CAUTION:
Hold the chain saw firmly with
both hands when the motor is running.
CAUTION:
Do not overreach. Keep proper
footing and balance at all times.
NOTICE:
Never toss or drop the tool.
NOTICE:
Do not cover the vents of the tool.
Pruning trees
Bring the chain saw body into contact with the branch
to be cut before switching on. Otherwise it may cause
the guide bar to
in injury to
the wood to
by just moving
tank, lay
on its
The proper
is 200
the tank, make sure
the chain
the tree.
wobble, resulting
operator. Saw
be cut
it down
20 ENGLISH
by using the
saw. ►
Fig.20
If you cannot cut the timber right through with a single
stroke:
Apply light pressure to the handle and continue
sawing and draw the chain saw back a little. ►
Fig.21
When cutting thick
make a shallow
then make the
top. ►
from the
If you try to cut off thick branches from the bottom, the
branch may close in and pinch the saw chain in the cut.
If you try to cut off thick branches from the top without
a shallow undercut, the branch may splinter. ►
Fig.23
Carrying tool
Before carrying the tool, always apply the chain brake
and remove the battery cartridges from the tool. Then
attach the guide bar cover. Also cover the battery
cartridge with the battery cover.
►
Fig.24: 1. Guide bar cover 2. Battery
cover

MAINTENANCE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
CAUTION:
Always wear gloves when
performing any inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other
or adjustment should
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
Sharpening the saw chain
Sharpen the saw chain when:
•
Mealy sawdust
when damp
cut;
•
The chain penetrates the
with difficulty,
heavy pressure
•
The cutting edge
damaged;
•
The saw pulls
left or
the wood.
sharpening of the saw chain or damage to one
side only)
weight of the chain
branches, first
undercut and
finish cut
Fig.22
maintenance
be performed by
is produced
wood is
wood
even when
is applied;
is obviously
to the
right in
(caused by uneven