Makita DUC256 Betriebsanleitung Seite 22

Cleaning the oil discharge hole
Small dust or particles may be built up in the oil
discharge hole during operation. These dust or
particles may impair the oil
and cause an
lubrication on the
chain. When a poor chain oil delivery occurs at the top
of guide bar, clean the oil discharge hole as follows.
1. Remove the sprocket cover and saw chain from
the tool.
2. Remove the small dust or particles using a slotted
screwdriver or the like.
►
Fig.32: 1. Slotted screwdriver 2. Oil
discharge hole
3. Insert the battery cartridge into the tool. Pull the
switch trigger
built-up dust
off the
discharge hole by discharging chain oil.
4. Remove the battery cartridge from the tool.
Reinstall the sprocket cover and saw chain on the tool.
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features, the following maintenance
must be performed regularly. Warranty claims can be recognized only if this work is performed regularly and
properly. Failure to perform the prescribed maintenance work can lead to accidents! The user of the chain saw must
not perform maintenance work which is not described in the instruction manual. All such work must be carried out
by our authorized service center.
Check item / Operating time
Chain saw Inspection.
Cleaning.
Check at
authorized
service
center.
Saw chain Inspection.
Sharpening if
necessary.
Guide bar Inspection.
Remove from
the chain saw.
Chain brake Check the
function.
to flow
insufficient
whole saw
to flow
or particles
oil
Before Everyday
operation
-
-
- -
-
- -
- -
-
22 ENGLISH
Replacing the sprocket
CAUTION:
A worn sprocket will damage a
new saw chain. Have the sprocket replaced in
this case.
Before fitting a
chain, check the
the sprocket.
►
Fig.33: 1. Sprocket 2. Areas to be worn
out
Always fit a
ring when replacing the
►
Fig.34: 1. Locking ring 2. Sprocket
NOTICE:
Make sure that the sprocket is installed
as shown in the figure.
Storing the tool
1. Clean the tool before storing. Remove any chips
and sawdust from the tool after removing the
sprocket cover.
2. After cleaning the tool, run it under no load to
lubricate the saw chain and guide bar.
3. Cover the guide bar with the guide bar cover.
4. Empty the oil tank.
Every week Every 3
month
- -
- -
- -
- -
- -
- -
- -
- -
new saw
condition of
new locking
sprocket.
Annually Before
storage
- -
- -
- -
-
- -
-
- -