Removing The Polystyrene Block; Changing The Door Hinges - hanseatic HMGS5144FW Gebrauchsanleitung

Page EN-20 Start-up
If the appliance is not positioned securely,
3. Close the doors.
4. Tilt the appliance backwards slightly.
5. Screw/unscrew the screw-on feet (3) until
the appliance is level.
6. Reposition the appliance upright.
7. Check the alignment with a spirit level.
The appliance should not move when
opening the doors.
Removing the polystyrene
block
4
5
3
0
2
1
Between the compressor (09) and bottom of
the cooling compartment (8) there is a poly-
styrene block (7) which is there to protect the
compressor against vibrations during trans-
port. You must remove it before start-up.
4
5
3
0
2
1
• Remove the polystyrene block (7) at the
rear of the appliance.

Changing the door hinges

You can change the side on which the door
opens. The door hinges are on the right upon
delivery.
As this alteration requires some manual skills,
please read through the work instructions be-
fore altering.
In addition to the package contents, you will
require:
– a medium sized cross-slotted screwdriver,
– a fine flat-headed screwdriver,
– a 10 mm wrench or combination wrench,
– the assistance of another person, where
possible.
1. Ensure that the appliance is not connect-
ed to the power supply.
(12) (11)
(8)
(7)
(09)
2. Using a flat-head screwdriver, carefully
pry out the blind covers (10) and (11) on
the top of the appliance and the blind
plugs (12) on the door frame.
3. Loosen the three screws (13) on the up-
per hinge (14), and remove these. As a
precaution hold the door itself with one
hand, or please ask a second person to
hold the door.
4. Remove the upper hinge (14).
5. Lift the door from the lower hinge, and set
aside.
6. Tilt the appliance backwards slightly, and
(7)
rest it against a wall.
(10)
(13)
(14)