Horizon Fitness T5.1 Bedienungsanleitung Seite 12

USING YOUR MEDIA PLAYER
1) Cable connection
a)Connect the included AUDIO ADAPTOR CALBE to AUDIO JACK on the left of the console and headphone jack on
your media player
b)Use media player buttons to adjust song settings
c)Use volume buttons on the media player or console to turn on or down the volume
2) Bluetooth connection
a)Connect the media player to Bluetooth device (WLT2564M) on the console
b)Use media player buttons to adjust song settings
c)Use volume buttons on the media player or console to turn on or down the volume
ENERGY SAVER (STANDBY MODE)
This machine has a special feature called Energy Saver mode. This mode is NOT automatically activated. When Energy
Saver mode is activated, the display will automatically enter standby mode (Energy Saver mode) after 15 minutes of
inactivity. This feature saves energy by disabling most power to the machine until a key is pressed on the console. This
feature can be turned on or off in the engineering menu.
To enter the engineering menu, press and hold the INCLINE
to SWITCH FUNCTION and press ENTER. Press ENTER to select Energy Saver mode, use
OFF. Press and hold STOP for 3-5 seconds to exit SWITCH FUNCTION. Press and hold STOP again for 3-5 seconds to exit
the engineering menu.
22
HZ16_OG_ELITE_5.1_7.1_Rev_1_A.indd 22-23
key and SPEED key for 3-5 seconds. Use to navigate
to select ENERGY SAVE ON or
PASSPORT MEDIA PLAYER
™
The Passport player, featuring Virtual Active™ technology, is a
high-definition experience that uses real destination footage and
matching ambient sounds from stunning destinations around
the world. The ultimate in workout entertainment, Passport
lets you escape the confines of a regular workout routine while
enjoying a dynamic experience.
A Passport player is available for purchase separately from your
Horizon Fitness® retailer.
world.passportplayer.com
For more information, go to:
SYNCING CONSOLE WITH PASSPORT
1) Use the arrow keys on the Passport remote to scroll to the setup icon and press select.
2) Follow the on-screen prompts to press on the equipment console.
3) The message displayed on screen will notify you if the sync was a success or failure.
23
12/6/16 11:55 AM