hanseatic HEKS8854GE Gebrauchsanleitung Seite 61

6. Open the refrigerator door out as far as
possible.
7. Push the door couplers (b) into the guide
rails of the elbows (a).
8. Screw the door couplers (b) on tight us-
ing the screws (e), while maintaining a
gap of approx. 18 mm to the edge of the
door of the built-in cabinet.
9. Close the door of the built-in cabinet and
check that the sliding guide between the
elbow (a) and the door coupler (b) func-
tion smoothly. If necessary, correct the
position of the door coupler.
10. A 6 mm gap must be kept between the
refrigerator and the built-in cabinet door
so that the refrigerator door can close
without any problems. To set the gap
width, loosen the screws (e) slightly and
manually set the desired distance. Then
tighten the screws (e) again.
18 mm
11. Open the refrigerator door out as far as
possible and push the long cover strips
(c) into the guide rails of the door cou-
plers (b).
12. Place the short cover strips (d) on the
elbows (a) as a cover.
13. Cut the joint profile (f) to the appropriate
length. Push it into the opposite side of
the door hinge between the refrigerator
and wall of the built-in cabinet.
14. Re-insert the glass shelves (8) and (9),
vegetable drawers (7) and the door
shelves (4) to (6).
You have successfully installed the refriger-
ator.
Page EN-27
Start-up
(c)
(d)