Brusa NLG41x Betriebsanleitung Seite 34

Manual
SAFT-option
Selection of the desired charging mode
Mode 1 Mode 2
open open
open closed
closed open
closed closed
With the two pushbuttons M(ode) 0 and M1 any of the four charging modes can be
selected. Note, that the state of the mode inputs are only read at the time, when the
charger is connected to the AC-mains after at least one minute off-mains operation.
Manipulation of the mode inputs while charging or discharging will take no effect with
one exeption: Both switches should be closed for a short time, when the control lamp
"maintenace charge request" lits again during a lnitialisation or maintenance charge.
This will end the process of charging to allow water topping of the batteries, what
should be done within the next few minutes.
Description of the program NLGMON.EXE
The program NLGMON.EXE is used for data visualisation during the charging
process. In order to accept the data stream from the charger, it is recommended to
run NLGMON on a PC.
Preparations: Connect the charger NLG4 directly to the preferred serial port.
If your computer has only a 25p connector, use a 25<->9p adapter.
Start of the program: (english version)
- - -> NLGMON
or
NLGMON 1
or
NLGMON 1 E
- - - > NLGMON 2
or
NLGMON 2 E
- - - > NLGMON D
or
NLGMON 1 D
NLGMON 2 D
- - - >
Manual
Software to NLG4
(Option SAFT charging profile)
normal charge
initialisation (commissioning) charge
maintenance charge
confirm "water topping" / fast charge
starts the program for COM1: English language
starts the program for COM2: English language
starts the program for COM1: German language
starts the program for COM2: German language
Brusa Elektronik
CH - 9473 Gams
Tel 081 750 35 30
Fax 081 750 35 39