Dometic B3200 Montage- Und Betriebsanleitungen Seite 30

FIG. 17
R a i s e B a c k
End Of ADB
To Ceiling
fig.17A
Screw Locations
Screw Locations
4. Your air conditioner is now installed and ready for
operation. Please read the following instructions
before attempting to run the unit.
Position ADB
Walls Inside
And Against
End Of Tem-
plate Walls
If Not Flush,
Wiggle Side To
Side.
install These 2 Screws
First
OPERATING INSTRUCTIONS
A. Controls
. The selector switch has ten positions including
"OFF". This controls fan speed, heating mode,
and cooling modes. See FIG. 8.
fig. 18
Selector Switch
2. The thermostat controls the compressor and Heater
ON/OFF operation in temperature range of 8.5°
C to 32.5° C. See FIG. 9.
B. Cooling Operation (Blue graphic)
. Set the thermostat at the desired temperature level.
See FIG. 9.
fig. 19
Blue graphic
Cooling
2. Select the fan speed that best satisfies your
needs:
a. HigH COOL: Selected when maximum cool-
ing and dehumidification required.
b. MED COOL: Selected when normal or average
cooling required.
c. LOW COOL: Selected when room is at desired
comfort level and needs to be maintained.
Normally this speed used for night time opera-
tion.
8
Thermostat
Gray Graphic
Fan
Colder
Red Graphic
Heating