Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attention points during operation
-
Make sure nobody is in the safety zone during the lifting or lowering of the vehicle.
-
When the vehicle is lifted to the desired height, the lift must be locked. Only when the lift is
locked, mechanics are allowed to work on the car.
-
Before lowering the vehicle, the work area under the car must be cleaned.
-
Check all moving parts weekly, grease the lifting body and check if all moving parts are well
lubricated and in the correct position.
-
Lower the lift completely and check the oil level in the tank. Make sure the oil tank is filled
almost to the MAX mark.
-
When you are not able to solve a problem, contact your Falco retailer.
6. Safety feature
Safety lock mechanism
CAUTION! Check the lift's safety lock mechanism before each use for proper functioning, failure to
heed these instructions may cause serious damage to materials or serious injuries!
Both sliding table are equipped with a mechanic locking mechanism, this mechanism is automatically
triggered when the lift is being raised and then lowered. In case you want to lower the lift
completely, raise the lift a little bit, then pull the lock releasing cord on the sliding table to release
the safety locking mechanism.
7. Maintenance
Cleaning the lift
The lift regularly has to be cleaned using a wet cloth to keep it clean. Before cleaning set the main
power switch to OFF-position, so the lift is not powered. The work area around the lift has to be
swiped clean. When large piles of dirt are gathered, this will accelerate the aging-process of the lift,
which decreases the bridge's lifetime.
General checks
-
Check all safety devices of the lift at the beginning of every day of work. The safety lock
has to function properly, the lock plate always has to fall into position. The lifting body
may not show any signs of wear and tear, cracks and/or deformation. If a defect is
discovered, put the lift out of use immediately until the broken part or malfunction is
repaired by a professional mechanic.
-
Check the chain for backlash daily, this could cause the chain to hit the cylinder which
may damage the cylinder, also check if it is still properly mounted to the column.
Maintenance of the hydraulic system
Cleaning and replacing oil
Three months after commissioning the lift, drain all oil out of the hydraulic system and fill the system
with new oil. Afterwards this has to be done every six months, clean the hydraulic system and
replace the oil.
26
Werbung
Inhaltsverzeichnis
