Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Operation
The 1-post lift can be used to lift vehicles up to a maximum weight of 2500kg, this way maintenance
and repairs can be carried out on the vehicle.
Preparing
Drive the car onto the lift over the ramps, put the car in de middle of the column, so the point of
gravity is centered opposed to the column and place the telescopic arms under the carriage of the
car. Make sure the weight of the vehicle is equally distributioned. In case the vehicle is not properly
positioned opposed to the lift, it is also possible to reposition the lift. Squeeze the lever of the pallet
jack and pump the handle to raise the lift, keep squeezing the handle and move the lift. When the lift
is in the correct position, release the lever, the lift now lowers to the floor.
Before lifting the vehicle, turn up the rubber pads until they support the lifting areas under the
vehicle as specified by the vehicle's manufacturer. Place the pad centered under the lifting point so it
supports the weight firmly and centered. Caution! Every vehicle is to be lifted correctly. It is possible
the manufacturer of the vehicle prescribes an adapter, read the vehicle's manual before lifting.
Lifting
When the power is connected, turn the main power
switch from position 'OFF' (1) to 'ON' (2), the green
light turns on (A,3). Push the LIFT-button (B,3) and
the car is raised. When the car is lifted 100-150mm
of the ground, release the button to stop lifting.
Move the car to make sure it sits firmly and stable on
the rubber pads. Now press the LIFT-button again to lift the vehicle to the desired height.
Stopping
Release the LIFT-button, the lift is automatically stopped.
Locking
Press the lever for lowering (C,4) downward and hold it for a couple of seconds untill the
lift is falls in the safety lock (the lift stops lowering). When the sliding tables have stopped
moving and are locked, let go of the handle. CAUTION! The lift has to be locked at all
times, before any work can be done to the vehicle.
Lowering
Press the LIFT-button (B,3) to release the safety locks, now pull the
lock releasing cord (5) on both sliding tables. Then press the lever
for lowering (C,4) down to lower the lift.
25
Werbung
Inhaltsverzeichnis
