Falco VL25F1 Montage- Und Bedienungsanleitung Seite 24

19. Place the blocks with the spring between them (105+104) in the appropriate recess in the
lifting body (refer to fig.19).
20. Now place the two levers (116+118), the pin of the lever must fall into the hole of the block
with teething (105), now secure the levers with the shaft with threaded end (107) by means
of a flat screwdriver (refer to fig.20).
21. Mount the plate (119) to the lifting body with the Allen bolts (21) and then mount the two
knobs (117) on both levers (refer to fig.21).
22. The next step is to place the lift arms on the column side
(78+98), to do this you have to be with two people. One
holds the arm and aligns the holes of the arm and the lift
body with each other and the other keeps locking pin
(123) up and places the pin (90) through the arm and lift
body (refer to fig.22).
23. Then place the lock washer (89) on the pin (90) by means
of a snap-ring pliers (refer to fig.23).
24. Then place the arms on the front of the lifting body
(101+111), here you also need two people. One holds the
arm and aligns the holes of the arm and the lift body with
each other and the other places the pin with the plate
(102+109) through the arm and lift body. Then fix the plate to
the lifting body with the Phillips head bolt (103) to secure the
pin (refer to fig.24).
25. Fix the yellow levers (81) on the arms (90) with the Allen bolts (refer
to fig.25).
26. Put the cable holder (110) against the lifting body (93) with the two
bolts (21) and place the cable (61) through it (refer to fig.26).
27. Finally, place the flexible cover (23) on the column(93), first put the
bracket (31) through the cover and mount it at the top very lightly
with the two M8 bolts (30)( refer to fig.27).
28. Position the flexible cover (23) through the slit in
the lifting body(93), then make two holes in the
flexible cover and fix it to the bottom with the
plate (22) and the two M6 bolts(21)(refer to
fig.28). Then tighten the bolts at the top of the
column to stretch the canvas.
23