General Information; Manual Keeping; Intended Use - Falco VL25F1 Montage- Und Bedienungsanleitung

1. General Information

Before starting to use the machine you need to read and fully understand the manual!!!
This manual contains important information about the proper way of installing, operating and
maintaining of the equipment described in this manual. When using any one post lift there are a
different kind of risks that you may incur, risks in personal injuries or property damage. Everyone
who comes into contact with the installation, maintenance or operation of the one post lift must be
fully familiar with the contents of this manual. To protect yourself against personal injury or property
damage you need to follow the following information and instructions in this manual.
Every Falco one post lift is manufactured in accordance with the Machinery Directive 2006/42/EC and
the NEN-EN 1493 norm. Every one post lift is supplied with a manual including a declaration of
conformity. These must be stored and kept up to date properly.
Because of quality reasons constant improvements are going to be made on the equipment, Falco
reserves the right to alter specifications of the equipment described in this manual.

Manual keeping

For a proper use of this manual, the following is recommended:

Keep the manual near the lift, in an easy accessible place.

Keep the manual in an area protected from damp.

Use this manual properly without damaging it.

Any use of the machine made by operators who are not familiar with the instructions and
procedures contained herein shall be forbidden.
This manual is an integral part of the machine: If and when the lift is being resold, the manual shall
be given to the new owner.

Intended use

The lift is strictly designed for lifting vehicles so the vehicle can be examined, for carrying out
maintenance and repairs. It's strictly forbidden to use the lift for lifting persons.
Its presumed that the floor supporting the lift is horizontal, smooth and strong. The floor should be
at least 10cm thick and should be at least strength class C20-25.
19