Functional Description; Intended Use; Product Features - Bosch GST 75 BE Professional Originalbetriebsanleitung

OBJ_BUCH-171-004.book Page 18 Thursday, June 17, 2010 11:43 AM
18 | English
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Products sold in GB only: Your product is fit-
ted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to
BS 1362).
If the plug is not suitable for your socket out-
lets, it should be cut off and an appropriate
plug fitted in its place by an authorised cus-
tomer service agent. The replacement plug
should have the same fuse rating as the orig-
inal plug.
The severed plug must be disposed of to
avoid a possible shock hazard and should
never be inserted into a mains socket else-
where.
Products sold in AUS and NZ only: Use a re-
sidual current device (RCD) with a rated re-
sidual current of 30 mA or less.

Functional Description

While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.

Intended Use

The machine is intended for making separating
cuts and cut-outs in wood, plastic, metal, ce-
ramic plates and rubber while resting firmly on
the workpiece. It is suitable for straight and
curved cuts with mitre angles to 45°. The saw
blade recommendations are to be observed.
1 609 929 W89 | (17.6.10)
Downloaded from www.Manualslib.com
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
manuals search engine

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 Lock-on button for On/Off switch
2 On/Off switch
3 Allen key
4 Thumbwheel for stroke rate preselection
5 Vacuum connection
6 Base plate
7 Adjusting lever for orbital action
8 Switch for sawdust blowing device
9 Guide roller
10 Saw blade*
11 Contact protector
12 Dust cover for vacuuming*
13 Handle (insulated gripping surface)
14 Stroke rod
15 SDS clamping lever for saw blade release
16 Vacuum hose*
17 Extraction adapter*
18 Splinter guard*
19 Scale for mitre angle
20 Screw
21 Angle gauge**
22 Bolt hole
23 Positioning pin/mark
24 Lead for the parallel guide
25 Locking screw for parallel guide*
26 Parallel guide with circle cutter*
27 Centring tip of the parallel guide*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
**Commercially available (not included in the deliv-
ery scope)
Bosch Power Tools