Operation With The Buttons On The Tv - Finlux Lugano50FL/UHD Bedienungsanleitung

TV Control Buttons & Operation
1. Standby On/Off button
2. TV/AV button
3. Programme Up/Down buttons
4. Volume Up/Down buttons

Operation with the Buttons on the TV

Press
button to increase the volume, so a volume
level scale (slider) will be displayed on the
screen. Press P/CH + button to select the
next programme or P/CH - button to select
the previous programme.
Press the
same time to view the main menu. In the
Main menu select a sub-menu using TV/AV
button and set the sub-menu using
or buttons. To see what options are
available via the menu, refer to the menu
system section of this manual. Press the
TV/AV button in the control panel on the TV to switch
between AV modes.
Note: Function indications of the buttons will be
displayed on the screen when pressed.
Downloaded from www.Manualslib.com
button to decrease the volume or
or button at the
manuals search engine
" " , switch is used for turning the TV on or off.
Inserting the Batteries into the Remote
Lift the cover on the back of the remote upward
gently. Install two AAA batteries. Make sure to
match the + and - ends of the batteries in the
battery compartment (observe the correct polarity)
Replace the cover.
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable/Satellite Connection
Connect the aerial or cable TV plug to AERIAL INPUT
(ANT-TV) or satellite lead to LNB INPUT(ANT SAT)
socket located on the rear bottom side of the TV.
Rear bottom side of the TV:
English - 36 -
Aerial or Cable