Rehau RAUSIKKO C3 X Einbau Und Wartung Seite 32

32
To avoid mistakes when cutting up
the matrices, mark the required
geometry in advance with an
appropriate marking pen.
It must be ensured that a suitable
fine-tooth saw blade with a cutting
depth of 60 – 70 mm is used.
There are four holes on every side
for threading the saw blade.
For connecting
▪ RAUSIKKO boxes (S/SC/H/HC/
SX/SX-HT)
▪ Front connection branches
DN200/DN250
the rectangular, rounded channel
matrix should be opened. Depen-
ding on the application and the required flow rate quantity, it
may be enough to saw out only individual openings.