Selecting A Digital Audio Format; Selecting Languages For Audio, Subtitles, And Teletext; Using Software Update; Using Auto Update - Pioneer KURO PDP-LX6090 Bedienungsanleitung

Enjoying DTV broadcasts

Selecting a digital audio format

Use the following procedure to switch between the PCM and Dolby
digital audio format.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "DTV Setup" (/ then ENTER).
4 Select "User Preferences" (/ then ENTER).
5 Select "Digital Audio" (/).
6 Select "PCM" or "Dolby" (/).
User Preferences
Digital Audio
Language Settings
Note
• You can select "DTV Setup" only when watching DTV channels.
Selecting languages for audio,
subtitles, and teletext
You may manually configure language settings for audio, subtitles,
and teletext.
1 Repeat steps 1 to 4 provided for Selecting a digital audio
format.
2 Select "Language Settings" (/ then ENTER).
3 Select "Primary Audio", "Secondary Audio", "Primary
Subtitle", "Secondary Subtitle" or "Teletext" (/).
4 Select a language (/).
Note
• The flat screen TV automatically selects the language based on
the "Country" setting (page 27) when the selected language for
audio, subtitle, or teletext is not available.
• You can select "DTV Setup" only when watching DTV channels.
Downloaded From TV-Manual.com Manuals

Using Software Update

This function downloads and updates the system's software at the
specified timing.

Using Auto Update

With this function on, the flat screen TV checks if updated software
is available and then downloads it (as necessary). After this, the
system executes Add New Channels operation (page 40). This
series of operations are automatically executed at the specified
time.
1 Press HOME MENU.
2 Select "Setup" (/ then ENTER).
3 Select "DTV Setup" (/ then ENTER).
PCM
4 Select "Software Update" (/ then ENTER).
5 Select "Auto Update" (default) (/).
6 Select "On" (/).
• We recommend that you normally select "On".
• For Auto Update to start, there must be approximately two hours
left before the start of the next preset recording/watching.
• 60 seconds before the scheduled update, a message prompt
appears asking if you want to carry out Auto Update or not. Auto
Update automatically starts if "OK" is selected or no selection is
made after 50 seconds.
• While an update is in progress, no TV image is output to the
external output terminal.
• To quit an update in progress, press HOME MENU.
• You can select "DTV Setup" only when watching DTV channels.
Software Update
Auto Update
Set Update Time
Start Manual Update
Technical Information
Note
09
On
43
En