Basic Connections; Connecting The Antenna; Routing Cables - Pioneer KURO PDP-LX6090 Bedienungsanleitung

Preparation
Caution
• A table or rack with adequate strength should always be used to
support the flat screen TV. Failure to do so could result in
personal injury and physical damage.
• When installing the flat screen TV, please take the necessary
safety measures to prevent it from falling or overturning in case
of emergencies, such as earthquakes, or of accidents.
• If you do not take these precautions, the flat screen TV could fall
down and cause injury.
• The screws, hooks, cords and other fittings that you use to
secure the flat screen TV to prevent it from overturning will vary
according to the composition and thickness of the surface to
which it will be attached.
• Select the appropriate screws, hooks, cords, and other fittings
after first inspecting the surface carefully to determine its
thickness and composition and after consulting a professional
installer if necessary.

Basic connections

Connecting the antenna

To enjoy a clearer picture, use an outdoor antenna. The following is
a brief explanation of the types of connections that are used for a
coaxial cable.
Caution
• When the "Aerial Power" setting is on, directly connect the
aerial to the ANT input terminal at the rear of the flat screen TV.
Connecting any device between the aerial and flat screen TV
may cause damage to the device.
Rear view
Standard DIN45325 plug (IEC169-2)
75-ohm coaxial cable (round cable)
(commercially available)
• Connect a 75-ohm coaxial cable (commercially available) to the
ANT terminal.
• If "Aerial Power" setting is enabled, use an indoor antenna with
signal amplifier, 5 V 30 mA.
Downloaded From TV-Manual.com Manuals
T T
W W
Antenna cable (commercially available)
If your outdoor antenna uses a 75-ohm coaxial cable with a
standard DIN45325 plug (IEC169-2), plug it into the antenna
terminal at the rear of the flat screen TV.
Note
• If the antenna is not connected correctly, the quality of
reception may be impaired. If images are not displaying
correctly, check whether the antenna connection is correct or
not.

Routing cables

When the speaker is mounted to the flat screen TV panel:
(PDP-LX6090)
Speaker cable
(PDP-LX5090)
Speaker cable
T
W
Cable clamp
(PDP-LX6090) Speaker cable
(PDP-LX5090) Speaker cable
Note
• Use the supplied cable clamps as necessary.
• When tidying up your speaker cables, make sure to bundle them
so that they are not subjected to any pressure.
(Side speaker)
Cable clamp
T
W
(Side speaker)
(Under speaker)
Cable clamp
(Under speaker)
Cable clamp
05
17
En