Preparing The Remote Control Unit; Inserting Batteries; Operating Range Of The Remote Control Unit - Pioneer KURO PDP-LX6090 Bedienungsanleitung

Preparation

Preparing the remote control unit

Inserting batteries

1 To open push and slide the battery cover in the direction of
the arrows.
2 Load the supplied two AA size batteries while inserting
their respective negative polarity (–) ends first.
Place batteries with their terminals corresponding to the (+) and (–)
indicators in the battery compartment.
3 Close the battery cover.
Caution
Improper use of batteries can result in chemical leakage or an
explosion. Be sure to follow the instructions below.
• When you replace the batteries, use manganese or alkaline
ones.
• Place the batteries with their terminals corresponding to the (+)
and (–) indicators.
• Do not mix batteries of different types. Different types of
batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and new batteries
can shorten the life of new batteries or cause chemical leakage
in old batteries.
• Remove batteries as soon as they have worn out. Chemicals
that leak from batteries can cause a rash. If you find any
chemical leakage, wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter life
expectancy due to storage conditions.
• If you will not use the remote control unit for an extended period
of time, remove the batteries from it.
• WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY
WITH GOVERNMENTAL REGULATIONS OR
ENVIRONMENTAL PUBLIC INSTITUTION'S RULES THAT
APPLY IN YOUR COUNTRY/AREA.
Downloaded From TV-Manual.com Manuals
Operating range of the remote control
unit
Operate the remote control unit while pointing it toward the remote
control sensor located at the bottom right of the front panel of the
flat screen TV. The distance from the remote control sensor must be
within 7 m and the angle relative to the sensor must be within 30
degrees in the right, left, upward, or downward direction.
Note
• For remote control sensor locations, see Part names on page 12.
Caution
• Do not expose the remote control unit to shock. In addition, do
not expose the remote control unit to liquids, and do not place
in an area with high humidity.
• Do not install or place the remote control unit under direct
sunlight. The heat may cause deformation of the unit.
• The remote control unit may not work properly if the remote
control sensor of the flat screen TV is under direct sunlight or
strong lighting. In such case, change the angle of the lighting or
flat screen TV, or operate the remote control unit closer to the
remote control sensor.
• When any obstacle exists between the remote control unit and the
remote control sensor, the remote control unit may not function.
• As the batteries become empty, the remote control unit can
function within a shorter distance from the remote control
sensor. Replace the batteries with new ones early enough.
• The flat screen TV emits very weak infrared rays from its screen.
If you place such equipment operated through infrared remote
control as a VCR nearby, that equipment may not receive
commands from its remote control unit properly or entirely. If
this is the case, place that equipment at a location far enough
from the flat screen TV.
• Depending on the installation environment, infrared rays from
the flat screen TV may not allow this system to properly receive
commands from the remote control unit or may shorten
allowable distances between the remote control unit and the
remote control sensor. The strength of infrared rays emitted
from the screen differs, depending on images displayed on the
screen.
05
19
En