Hitachi RAS-25CNH2 Bedienungsanleitung Seite 13

HOW TO EXCHANGE THE BATTERIES IN THE REMOTE CONTROLLER
1
Remove the cover as shown in the figure and take out the
old batteries.
2
Install the new batteries.
The direction of the batteries should match the marks in the
case.
! CAUTION
1. Do not use new and old batteries, or different kinds of batteries
together.
2. Take out the batteries when you do not use the remote controller
for 2 or 3 months.
TEMPORARY SWITCH
Use this switch to start and stop when the
remote controller does not work.
By setting the temporary switch, the
G
operation is done in previously set operation
mode.
When the operation is done using the
G
temporary switch after the power source is
turned off and turn on again, the operation
is done in automatic mode.
=
– 13 –
Push and pull to the
direction of arrow
TEMPORARY SWITCH
POWER SWITCH