Adjusting The Cutting Depth - Flex MS 1706 FR Bedienungsanleitung

Wall chaser MS 1706 FR

Adjusting the cutting depth

1. Pull out the mains plug.
2. Depress the lock on the milling depth stop
(2b) and set the stop to the required
depth. Lock the milling depth stop (2b)
at the required depth.
Dust extractor
Caution!
During operation the wall chaser must be
connected to a dust extractor.
The extraction system must be authorised
to extract stone dust.
An authorised special extractor must be
used to extract particularly harmful,
carcinogenic, dry dust.
If the extraction system malfunctions, stop
working immediately and switch off the
power tool. Repair the fault before switching
on the power tool again.
n Connect the hose from the extraction
system to the intake flange. Check the
attachment! If required, use an
appropriate adapter.
Downloaded from www.Manualslib.com manuals search engine
Making cuts
Danger!
The stipulated cutting direction is indicated
by the cutting-direction arrow (10) on the
guard hood and must always be observed.
Always guide the wall chaser with both
hands. Use the designated gripping areas.
One hand on the power tool, the other hand
on the handle (4) or (7).
If there is a risk of cutting through live
cables, do not touch the metal parts of the
machine.
Diamond cutting discs become very hot
during operation. Do not touch them until
they have cooled down.
1. Position the power tool milling table (1)
fully on the area which is to be
processed.
To align with marks, use the notch in the
milling table.
2. Switch on the device.
3. Press the release rocker (8) and slowly
lower the milling unit and immerse into
the material.
4. Move the wall chaser in the indicated
cutting direction.
5. After making the cut, swivel the power
tool – with the motor running – all the
way out of the groove until the release
rocker (8) engages.
19