Flex MS 1706 FR Bedienungsanleitung Seite 18

Note
The rough side of the quick-release
clamping nut always faces the cutting disc
or distance washer.
5. Remove the cutting discs (b), clamping
flange (d) and distance washers (c).
To change the cutting discs:
n Attach new cutting discs (b), distance
washers (c) and clamping flange (d) in
reverse sequence.
n Screw on the quick-release clamping nut
(a). Depress the spindle lock (12) and
manually tighten the quick-release
clamping nut (a).
To change the groove width:
The groove width can be set by rearranging
the distance washers.
Note
The minimum groove width is 10 mm. In all
distance washers (c) are fitted in front of the
quick-release clamping nut (a).
18
Downloaded from www.Manualslib.com manuals search engine
Wall chaser MS 1706 FR
n Attach the cutting disc (b), distance
washers (c) according to the required
groove width and clamping flange (d).
n Attach the remaining distance washers
(c).
n Screw on the quick-release clamping
nut. Depress the spindle lock (12) and
manually tighten the quick-release
clamping nut (a).
6. Gently depress the milling unit and
attach the guard hood (3).
7. Lift lock (5) for guard hood and rotate
by 180° until it engages.
8. Insert the mains plug into the socket.
9. Switch on the wall chaser (without
locking the switch) and leave running for
approx. 30 seconds. Check for quiet
running.