Flex MS 1706 FR Bedienungsanleitung Seite 16

n Always lay the power cord (11) to the
rear away from the wall chaser.
n Use only diamond cutting discs which
have a permitted speed at least as high
as the idling speed of the power tool.
n Use only diamond cutting discs which fit
the chuck. Do not use reducers or
adapters.
n Before using the power tool, check that
the tools have been fitted and attached
correctly. Switch on the machine at no
load for 30 seconds!
Interrupt the test run immediately if
violent vibrations occur or other damage
is established. Check the machine to
determine the cause.
n Caution when working in unknown
areas!
Electric, gas or water lines below the
surface may be damaged.
Use suitable detectors to scan the work
area beforehand.
n Caution when working in supporting
walls! Observe structural
calculations!
Before starting work, obtain the
permission of the structural engineer,
architect or site manager responsible.
The permitted chasing depth depends
on the chasing length, wall thickness
and building material.
n Do not work in materials which release
hazardous substances (e.g. asbestos).
n During operation the wall chaser must
be connected to a dust extractor.
The extraction system must be
authorised to extract stone dust.
An authorised special extractor must
be used to extract particularly harmful,
carcinogenic, dry dust.
16
Downloaded from www.Manualslib.com manuals search engine
Wall chaser MS 1706 FR
n Keep hands away from rotating tools.
n Before putting down the power tool,
switch it off and wait until it comes to
a standstill.
n Blocking the cutting discs will result in
considerable recoil forces. Switch off the
power tool immediately.
n Do not use the wall chaser in rain or in
a damp environment.
n If wall chasers are used outdoors or are
exposed to excessive amounts of metal
dust, connect them via a residual-
current-operated circuit-breaker
(tripping current maximum 30 mA).
n Use only extension cables permitted for
outdoor use.
n Identify the wall chaser with stickers
only. Do not drill any holes into the
housing.
Damage to property!
n The mains voltage and the voltage
specifications on the rating plate (15)
must correspond.