Playing Back; After Setting The Built-In Battery; Locking The Controls (Hold) - Sony Network Walkman NW-HD1 Bedienungsanleitung

Playing Back

Transfer audio data from your computer to the
player beforehand (  page 14).
You can change the language to your own for
the menu and the messages in the display ( 
page 27).
1

After setting the BUILT-IN BATTERY

switch to ON (  page 8), connect
headphones to the player.
Headphones
2
Press 

(play) appears on the left bottom of
the display and the player starts playback.
 appears.
18
to  (headphones)/
LINE OUT jack
.

3
Adjust the volume by pressing
VOLUME + /–.
Notes
• When using the built-in battery, if the player is not
operated for about 30 seconds while in stop mode,
the display automatically turns off. When scrolling
track titles, etc., the display turns off about 30
seconds after scrolling is finished.
• When using the AC power adaptor, if the player
is not operated for about 3 minutes while in stop
mode, the display automatically turns off. When
scrolling track titles, etc., the display turns off
about 3 minutes after scrolling is finished.
• If playback does not start, make sure that the
HOLD switch is set to off (  below).
Locking the controls
(HOLD)
You can prevent accidental button presses
while carrying the player by locking the
controls. "HOLD" flashes on the display
if you press any button when the HOLD
function is activated.
1
Slide the HOLD switch in the
direction of the arrow.
To unlock the controls
Slide the HOLD switch in the direction
opposite to that of the arrow.
VOLUME + /–