Timex TX730 Bedienungsanleitung Seite 4

o v e r v i e w
Declination scale
Upper hand
2nd time zone time and
chrono hours scale
Hour hand
Tachymeter scale
BUTTON C
(COMPASS)
4th Center hand
(pointing end)
Second hand
IMPORTANT: The compass must be calibrated before use.
(SEE COMPASS CALIBRATION)
Minute hand
BUTTON A
(START/STOP)
Date window
Closed position
Middle position
Outer position
CROWN
Chrono minutes scale
BUTTON B
(FLY-BACK/RESET)
Lower hand
Compass ring
2
NOTE: Your TX™ watch crown has three positions, closed, middle and
outer. To accustom yourself to the difference between the various posi-
tions extend the crown to its outer position and then push the crown
very lightly until you feel it click into the middle position.
d a t e a n d t i m e s e t t i n g
To set the date and time:
1) Pull the crown to its middle position and turn it until the correct date
appears in the date window.
2) Pull the crown to its outer position and turn it until the correct time is
shown. Ensure AM/PM setting is correct by verifying that the date
changes at midnight, not noon.
3) Push the crown in when finished.
For months with fewer than 31 days, the date will need to be adjusted.
i n d i c a t o r h a n d ( 4 t h c e n t e r h a n d ) a d j u s t m e n t
To readjust a misaligned indicator hand:
1) Pull the crown to its outer position. The upper and lower hands reset
to the ends of their sweeps automatically.
2) The 4th center hand should point to 12 o'clock. If it does not within 5
seconds of pulling the crown to its outer position, press A or B to
move the hand counterclockwise or clockwise, respectively, until it
points to 12 o'clock.
3) Push the crown in when done.
3