Reprocessing Transmission Instruments; Auf 1 Holder For Transmission Instruments; Optional Components - Miele A 315 Gebrauchsanweisung

Reprocessing
transmission
instruments
Optional compon-
ents
Check that internal sections of transmission instruments are free of

blockages.
Insert the transmission instrument into the holder. The instrument is

then held in position by the spring clamp.
After reprocessing pull the transmission instrument out of its holder.

The spring clamp will automatically spring back to its starting
position.
After reprocessing, the insides of the instruments must be dried

with sterile compressed air before being cleaned and sterilised as
appropriate in accordance with the manufacturer's instructions.
Please observe national regulations.
Before using transmission instruments again following repro-
cessing, a function check must be carried out, e.g. by spraying into
a basin, to ensure they are clear.

AUF 1 holder for transmission instruments

AUF 1 holders are designed for reprocessing dental transmission in-
struments.
– A 801, threaded adapter
– ADS 1, silicone adapter, white, for holding transmission instruments
with a  of approx. 20 mm
– ADS 2, silicone adapter, green, for holding transmission instruments
with a  of approx. 16 mm
– ADS 3, silicone adapter, red, for holding transmission instruments
with a  of approx. 22 mm
– FP 20, 20 filter plates, porosity 2,  30 mm
en - Areas of application
41