Cameo ROOT PAR 4 Bedienungsanleitung Seite 14

Slave Group 0
No delay
Master unit
Auto Programme 1
Delay 0.5 s
SYSTEM SETTINGS (Settings)
Starting from the main display, press MODE to enter the main menu. Use UP and DOWN to select the menu item Settings and confirm with
ENTER.
--------Menu-------
DMX Address
DMX Mode
DMX Delay
Standalone
Slave
Settings
System Info
This will take you to the submenu for setting the submenu items (see table, select with UP and DOWN, confirm with ENTER, change value or
status with UP and DOWN, confirm with ENTER).
SYSTEM INFORMATION (System Info)
Settings
Disp Rev = Rotate display
Disp Back = Display lighting
Sig Fail = Operating status
with DMX signal
fault
Sound = Sets music
control
PWM = LED PWM frequency
Calibration = Color calibration
(CLROOTPAR4)
Calibration = Color calibration
(CLROOTPAR6)
IR Remote = Activate or deactivate
control by IR
remote control
14
Slave Group 1
0.5 s delay
Mode
Mode
Slave
Slave
Gr 1 0.5
s
No
Yes
Off
On
Hold
Black
User 1
Last
Off
650 Hz, 1530 Hz,
2150 Hz, 4000 Hz
Red, Green, Blue,
White
Red, Green, Blue,
White, Amber, UV
On
Off
Slave Group 2 Slave Group 3
1 s delay 1.5 s delay
Mode Mode
Slave Slave
Gr 2 0.5 Gr 3
s
Mode
Slave
Gr 3
Mode
Slave
Gr 3
No display rotation
Display is rotated by 180°
(e.g. for overhead installation)
Deactivates after approximately 30 seconds of inactivity
On permanently
Last command is retained
Activates blackout
User Color 1 is activated
Color is retained until next impulse
Color expires after a moment, until next impulse
Select LED PWM frequency
Individual color calibration. Cross-mode brightness setting of
the 4 LED groups RGBW with values from 0 to 255
Individual color calibration. Cross-mode brightness setting of
the 6 LED groups RGBWA+UV with values from 0 to 255
IR remote control activated
IR remote control deactivated
Slave Group 4 Slave Group 5
2 s delay 2.5 s delay
Mode
Slave
0.5 Gr 4 0.5 Gr 5
s s
0.5
s
0.5
s
Mode
Slave
0.5
s