Cameo ROOT PAR 4 Bedienungsanleitung Seite 12

STANDALONE MODE LOOP
The standalone mode Loop allows you to individually configure, store and access up to four different color changing programmes. Bright-
ness, step time, fade time and delay (signal delay) are also separately configurable.
Starting from the main display, press MODE to enter the main menu. Now use UP and DOWN to select the menu item Stand Alone and
confirm with ENTER. Again use UP and DOWN to select the standalone mode Loop and confirm with ENTER. Using UP and DOWN, now
select the desired loop (Loop 1 to 4) and confirm with ENTER.
--------Menu-------
----Standalone----
DMX Address Auto
DMX Mode Static
DMX Delay Color Preset
Standalone User Color
Slave Loop
Settings
System Info
This will take you to the submenu for setting the submenu items (see table, select with UP and DOWN, confirm with ENTER, change value or
status with UP and DOWN, confirm with ENTER). The settings for each loop are made separately and are retained even after restarting the
device.
ROOTPAR4
STANDALONE MODE LOOP (Loop 1–4)
Dimmer Sets brightness
Step time Sets step time
Fade time Sets fade time in percent
Delay Delay time for slave groups
1st step
15 colors from Color Preset
4 colors from User Color
Blackout
2nd step
15 colors from Color Preset
4 colors from User Color
3rd step
Blackout
-------
4th step
12
----Loop Mode---- ---------Loop x---------
Loop 1 Dimmer
| Step time
Loop 4 Fade time
Delay
Step 1
Step 2
Step 3
Step 4
Red to CW (Cold White)
User 1 to User 4
"
Red to CW (Cold White)
User 1 to User 4
"
0–100
0.1 s to 10.0 s
0% to 100%
0.0 s to 2.0 s
Red
Green
Black
-------
0–100
0.1 s to 10.0 s
0% to 100%
0.0 s to 2.0 s
Blackout
"
Blackout
Skip step
"