Operation With A Control Panel; Dome Menu Structure With Dennard/Dm Controllers - Dedicated Micros 2060 Menü-Systemhandbuch

4. OPERATION WITH A CONTROL PANEL

NB: This will vary between control panels. Please refer to the Controller manual.
The Dome Camera's are an open protocol device. Consequently, there are several different
manufacturers' controllers available to drive it. All of the many features offered by the dome are
programmed from one of three menu structures. Each controller will have individual control
configurations which make it essential that the user reads the controller manual to ascertain which
button activation gives access to the menu features. Section 6 gives these functions for several
popular controllers.
The following instructions will guide you through the menu structure when using the Dome & PSU
(with address set to No. 253... DEN PANEL) controlled by either a Dennard/DM dtx400dc or
dtx1000dc

4.1 Dome Menu Structure with Dennard/DM controllers

The Menus appear on the screen when activated by the following commands:
Note that the 'shift' key must be held down while the selection is made.
On activation, the menu will appear on the monitor screen against the normal video scene
background with a cursor on the left hand edge. A choice is made by positioning the cursor over the
desired feature and operating an "ACCEPT" button(s) which, for the Dennard/DM controllers, is as
follows:-
User Menu
Supervisor Menu (password required) shift wipe
Technicians Menu (password required) shift autopan
For dtx1000dc, hold the preset button and press CAMERA SELECT 1
For dtx 400dc, press preset 1 button
2040 / 2060 Menu System Manual
Downloaded from www.Manualslib.com manuals search engine
dtx1000dc access
shift wash
dtx400dc access
shift 1
shift 2
shift 3
Page. 10