Chapter 3: Single Unit Operation; Rear Panel Indicator - Tdk-Lambda Rfe2500 Serie Bedienungsanleitung
Inhaltsverzeichnis
CHAPTER 3:
3.1
Rear Panel Indicator
1. DC OK – LED indicator:
GREEN
OFF
*J1 Mating connector comes with basic configuration settings.
Power supplies are factory programmed to the rated output voltage. For applications requiring lower / higher voltage,
power supplies should be adjusted to the required voltage before connection to the load.
SINGLE UNIT OPERATION
Output Voltage is above 90% ± 5% of set Output Voltage.
Output Voltage is below 90% ± 5% of set Output Voltage.
*J1
DC OK LED
Figure 3–1: Front Panel Indicator
J2
TB1
ATTENTION:
11
*Use UL approved Insulated Terminal Lugs
Inhaltsverzeichnis
