TDK-Lambda RFE2500 serie Bedienungsanleitung Seite 15

Notes:
Refer to (Paragraph 1.1).
*1
*2 For cases where conformance to various safety standards (UL, EN etc.) is required, input voltage to be
described as 100-240Vac (50/60Hz).
*3 At 115/230Vac, 25˚C ambient temperature.
*4 Not applicable for the noise filter inrush current less than 0.2mS.
*5 From 85~132Vac or 170~265Vac, constant load.
*6 From No-load to Rated load, constant input voltage. Measured at the sensing point in Remote sense.
*7 Measured with JEITA-RC9131A 1:1 probe with 4x270uF electrolytic capacitors and 1uF film capacitor on the
output, 20MHz B.W.
*8 Voltage drop on load wires: RFE2500-12: 0.25V/wire; RFE2500-24: 0.5V/wire; RFE2500-48: 1V/wire.
*9 Accuracy applicable for load current > 80% of rated output current. Derate maximum output power by 5%.
*10 Inverter shut down method. Reset by AC voltage recycle or by On/Off control.
*11 Measured with JEITA-RC9131A 1:1 probe with 470uF electrolytic capacitor and 0.1uF film capacitor on the
output, 20MHz B.W.
*12 Measured according to UL, EN method at 60Hz, 25˚C ambient temperature.
*13 Measured from input-off until the output voltage drops under 5% from the nominal voltage.
*14 Open collector signal. Maximum sink current: 10mA, maximum voltage 15V.
*15 RFE2500 series considered as professional equipment and not intended for sale to general public.
*16 Refer to Output Power vs. temp derating (Paragraph 1.2).
2