Operating The Device; Troubleshooting - Walimex Pro Sirius 160B-LED Gebrauchsanleitung

• When using several lamps at the same time with cable remote control:
Use the RJ45 cable to connect the individual lamps. On one lamp use the
RJ45 socket to connect the remote control.
• Plug the mains cable of the device into the DC socket on the device, then
connect the mains cable of the power supply unit with the outlet socket of
the electric power supply.
NOTE
Compare the local electric power supply with the connection values of
the device. Should the connection values not match, please contact
info@walser.de.
NOTE
After use disconnect the device from the local power supply by simply
pulling out the mains plug.
22

6. Operating the device

• Switch on the lamp on with the On/Off switch on the device.
• Adjust the desired light intensity with the brightness dimmer control.
• Adjust the desired colour temperature with the controller.
(depending on model type)
• After use operate the On/Off switch to switch off the lamp.

7. Troubleshooting

Problem Possible cause
The device is switched Power cord is not
on, but does not show plugged or plugged
any function. incorrect
The device is switched
off
The device has not
The illuminant does
enough power
not light
The device is defective
Remedy
Plug in the power cord
correctly
Switch on the device
Increase the power of
the dimmer control
Repairs must only be
carried out by a skilled
electrician
23